小苹果园

标题: Garmin导航仪硬重启的方法 [打印本页]

作者: admin 时间: 2015-10-8 22:01
标题: Garmin导航仪硬重启的方法

Hard Reset warnings:

* Note that this procedure has been known to delete your favorites so back them up beforehand: From the nuvi drive, copy x:/Garmin/GPX/current.gpx to your backup location. After the hard reset, copy current.gpx back to the same folder on the nuvi but rename it temp.gpx (important). On the next power cycle, the favorites will be read from temp.gpx into the non-user accessible memory area on the nuvi where they are actually stored (current.gpx is only a shadowed backup of your favorites)

* Note that this procedure will clear all user selected settings under Tools>Settings like map view mode, navigational settings, selected vehicle, selected voice, etc. These settings will need to be re-configured afterwards. It will also clear out your Recent Finds so make sure you save these as favorites or archive them in another way. Maps, vehicles, voices and user-loaded custom POI's stored on the unit will not be disturbed.

Hard Reset Procedure: (All except the 8x0/8x5/37xx series units):
1. Power the unit off.
2. Press and hold (and continue to hold) the bottom-right corner of the screen while powering the unit on.
3. Continue to hold the screen until the "Do you want to erase all user data?" prompt appears.
4. Press "yes" and the unit will reboot.

Reset all your location settings and user preferences. Also restore your favorites using the method outlined at the beginning of this post.

nuvi 8x0/8x5 series hard reset:
To perform a master reset on a nuvi 800 or 805 series device:

1. Remove battery from nüvi
2. Place battery back into nüvi
3. Touch-and-hold the bottom right corner of the touch screen when a progress bar appears
4. Release the screen when "Do you really want to erase all user data?" appears
5. Touch "Yes"

Reset all your location settings and user preferences. Also restore your favorites using the method outlined at the beginning of this post.

*Note that a "power-cycle" (or power-on/power off sequence) on the nuvi 8x0/8x5 units consists of removing, then reinserting the battery into the unit -or- sliding the power switch to the ON position and holding it there for ~10 seconds. Using the power switch normally on the unit (slide to ON position and immediately release) to power it off only puts the unit into a "sleep" mode.

nuvi 37xx series hard reset:

If possible after the hard reset (all units), let the unit sit outdoors in the open for about 30 minutes or so to let the unit re-acquire satellite almanac data.

作者: bym6668 时间: 2015-11-25 20:17
xuexixuexixuexixuexi

作者: bym6668 时间: 2015-11-25 20:19
学习学习。。。。。。。。。。。。。

作者: wuge 时间: 2016-6-17 22:00
赶紧学习！

作者: 红红火火 时间: 2016-10-18 21:01

太棒了，感谢楼主提供这么好的资源。

作者: fgfname 时间: 2017-4-12 20:49
太棒了，感谢楼主提供这么好的资源。

作者: amigo 时间: 2017-6-30 02:44
感谢楼主提供这么好的资源。

作者: admin 时间: 2017-7-3 00:15
太棒了，感谢楼主提供这么好的资源。

作者: wsy945 时间: 2018-10-27 12:21
英文看不懂

作者: gjk9988 时间: 2019-10-16 22:56
谢谢分享谢谢

作者: luchaohua 时间: 2020-2-16 17:21
看看学习一下，有用

作者: q8z8w84444 时间: 2020-4-9 22:30
如果您要查看本帖隐藏内容请回复

作者: carnus 时间: 2021-2-6 00:43
好资料，虽然是英文的，翻译一下即可

作者: Frankzhang1111 时间: 2021-3-8 09:43
谢谢楼主分享谢谢楼主分享

欢迎光临小苹果园 (http://bbs.lingsky.com/)